Next the walls need to be moved to the roof line to create the dormer.
Revit wont cut dormer roof.
When i erase the dormer walls and roof i have the hole in my roof where the dormer was located.
Structure tab opening panel dormer opening highlight the main roof on the building model and click to select it.
Select the wall tool and choose a wall from the type selector.
I made the dormers and the dormer openings the same way but on the rear of the building one line of the cut profile only seems to cut the roof in the vertical direction instead of both horizontally and vertically as all the other cut profile lines do.
The dormer cut has been left selected to show the modification.
Place the 3 walls in the plan view.
I have a roof that i have cut for a major gambrel dormer that is identical on both the front and rear of the building.
When that edge on the dormer gets too close to the same edge on the main roof the opening cut fails.
I want to eliminate of the dormers.
I placed two dormers in a gable roof and used the dormer opening tool to cut out the roof at the dormers.
Select the dormer cut and then select the edit dormer opening from the ribbon as shown in figure 8.
If so how do you do it.
Edit the dormer opening to reflect the roof modification as per figure 9.
I m not sure if you got this roof to join but here are a couple tricks to try.
Place the cursor in the drawing area.
On the properties palette set the top constraint for the walls to unconnected and specify a height of 4000.
Is it possible to remove a cutout for a dormer in a roof with revit.
Seems to be a geometry solver problem with the edges of the 2 roofs where the 2nd slope meets.
Change the visual style back to shaded to show the finished item as in.
It can be as little as 1 128.
If you make the dormer roof with a very slightly bigger overhang than the main roof it will then join to the main roof.
You can also create the dormer with a two cut plumb and the fascia depth set to zero so that the dormer has a flat.
If the 2 edges are far enough away from each other it works fine.
I cant seem to select the hole to remove it.
