Removing Carpet Spikes

If you re aggressive enough one or two solid blows with the hammer against the heel of the pry bar should be sufficient to dislodge the nails.

Removing carpet spikes.

Then grab the carpet by hand and continue to pull it up along an entire wall. After pulling up your carpet you will most likely have tack strips left around the perimeter of the room. For concrete subfloors tack strip or the actual nail removal can be frustrating. Use measuring tape to determine proper width image 1 then use a carpet blade to cut the carpet into 4 foot wide strips image 2.

Its not that hard with these tips from clay king from aaa flood drying with 28. If not cut the carpet near the top of the top stair riser. In order to remove carpet easily and efficiently it s best to cut the carpet into 4 foot wide strips. Carpet can stain and wear out over time so plan to replace it every five to ten years especially if it is installed in high traffic areas like living rooms.

In most cases glue down carpet cannot be lifted up without damaging the backing or tearing the carpet. Roll up the strips and tape them for easy handling. How to lift a carpet up without damaging it. Remove the baseboards and pull up a corner of the carpet using a claw puller or pliers.

Carpet is installed using glue or tack strips. You need to loosen about a foot of carpeting to attach to the machine. Begin at the top of the stairs. Just grab the carpet with pliers and pull.

Removing these strips that once held your carpet is the most tedious part of carpet removal. Fold the carpet over for easy cutting and slice it into narrow strips. If you are pulling up carpet from stairs. During removal small divots in the concrete will appear and should not be a concern.

To detach the carpet from the tack strip that holds the carpet in place along walls start in a corner.